Problem with intel 945G in "twin" mode

[Rohnny Moland]

So I should specify PCI:0:2:0 on both devices? I have tried that, and
also tried to add both Screen 0 and Screen 1 as you mention, without
any luck. The screens are just cloned.

Regards,
Rohnny

On 5/29/06, Dave Airlie <airlied at gmail.com> wrote:
> You have the wrong Pci id specified ..
>
> BusID should be PCI:0:2:0 the second ID is a windows only placeholder...
>
> you then need to add Screen 0 to the first Device section and Screen 1
> to the second one..
>
> Dave.
>
> On 5/27/06, Rohnny Moland <rmoland at gmail.com> wrote:
> > Hi Dave,
> >
> > Thanks for your reply. I have attached the log and config file.
> >
> > Regards,
> > Rohnny
> >
> > On 5/27/06, Dave Airlie <airlied at gmail.com> wrote:
> > > could you attach xorg.0.log? and xorg.conf the warnings are only warnings..
> > >
> > > Dave
> > >
> > > On 5/27/06, Rohnny Moland <rmoland at gmail.com> wrote:
> > > > Hi,
> > > >
> > > > I am trying to setup suse 10.1 with two monitors (in twin mode - as
> > > > one big screen). In xorg I have set Xinerama to true, and also setup 2
> > > > monitor, device and screen sections in xorg.conf.
> > > >
> > > > When I run, the screens are just cloned. In xorg.0.log I get this warning:
> > > >
> > > > (WW) I810(0): Bad V_BIOS checksum
> > > >
> > > > ..and also this one:
> > > >
> > > > (WW) I810(0): Extended BIOS function 0x5f28 not supported.
> > > >
> > > > Also display plane b is disabled for some reason:
> > > >
> > > > (II) I810(0): Display plane A is enabled and connected to Pipe A.
> > > > (II) I810(0): Display plane B is disabled and connected to Pipe B.
> > > > (II) I810(0): Enabling plane A.
> > > > (II) I810(0): Display plane A is now enabled and connected to Pipe A.
> > > > (II) I810(0): Display plane B is now disabled and connected to Pipe B.
> > > > (II) I810(0): PIPEACONF is 0x80000000
> > > > (II) I810(0): PIPEBCONF is 0x80000000
> > > >
> > > > I wonder if someone know what the reason could be for this, and how I
> > > > can get twin mode to work. I am using SuSE 10.1 with xorg 6.9.0.
> > > > Kernel version: 2.6.16.13-4. The graphics card is intel 945G, using
> > > > the i810 driver.
> > > >
> > > >
> > > > Thanks in advance,
> > > >
> > > > Rohnny
> > > > _______________________________________________
> > > > xorg mailing list
> > > > xorg at lists.freedesktop.org
> > > > http://lists.freedesktop.org/mailman/listinfo/xorg
> > > >
> > >
> >
> >
> >
>