R3XX lockup possible solution

[Jerome Glisse]

On 6/24/06, Christoph Brill <egore at gmx.de> wrote:
> Am Samstag, den 24.06.2006, 22:37 +0200 schrieb Christoph Brill:
> > Am Samstag, den 24.06.2006, 17:27 +0200 schrieb Jerome Glisse:
> > > ...
> > > Report your status.
> > >
> >
> > 01:00.0 VGA compatible controller: ATI Technologies Inc Radeon R300 ND
> > [Radeon 9700 Pro] (prog-if 00 [VGA])
> >         Subsystem: Elsa AG Unknown device 0c90
> >         Flags: bus master, VGA palette snoop, stepping, 66MHz, medium
> > devsel, latency 32, IRQ 169
> >         Memory at d8000000 (32-bit, prefetchable) [size=128M]
> >         I/O ports at c000 [size=256]
> >         Memory at e9000000 (32-bit, non-prefetchable) [size=64K]
> >         [virtual] Expansion ROM at e8000000 [disabled] [size=128K]
> >         Capabilities: [58] AGP version 2.0
> >         Capabilities: [50] Power Management version 2
> >
> > Status: success
> > Details: can finally run the quake 3 demo (couldn't do any 3d before
> > other than glxgears)

Can you try with commenting out code up to printf with S05 in it
and report again (do this after a cold reboot of your computer), i am
trying to isolate as much as possible the init we need.

> Quick note: ut works fine, ut2003 also (water does not look correct),
> neverball/neverputt look fine with known reflection issues

R3XX is still not feature complet, this another story, but easier i think :)

best,
Jerome Glisse