DRI with r300 on Radeon 9800 possible

[Jerome Glisse]

On 12/3/06, Florian Dorpmueller <dorpmueller at hotmail.com> wrote:
> >You likely have a wrong version of automake i think
> >default automake in ubuntu is bit old. Try apt-get install automake-1.7
> >or somethings like that.
> >
> >Please really check your tools version against the link
> >i give you earlier, don't assume ubuntu install the right one.
> >
>
> That was a good hint! automake was actually of version 1.4. Now I have
> installed version 1.7. Don´t know why ubuntu comes with an old version by
> default. After upgrading, the make process had no problemes.
>
> But in result nothing significant changed. I stick on "direct rendering No"
> although in the log DRI is marked as enabled.
>
> Maybe this could be interesting: "dmesg | grep drm" gives back two errors:
>
> [17179591.312000] [drm] Initialized drm 1.0.1 20051102
> [17179591.344000] [drm] Initialized radeon 1.25.0 20060524 on minor 0
> [17179617.736000] [drm] Setting GART location based on new memory map
> [17179617.736000] [drm] Loading R300 Microcode
> [17179617.736000] [drm] writeback test succeeded in 1 usecs
> [17179718.348000] [drm:r300_emit_carefully_checked_packet0] *ERROR* Offset
> failed range check (reg=4e28 sz=1)
> [17179718.348000] [drm:r300_do_cp_cmdbuf] *ERROR* r300_emit_packet0 failed
> [17179720.080000] [drm] Setting GART location based on new memory map
> [17179720.080000] [drm] Loading R300 Microcode
> [17179720.080000] [drm] writeback test succeeded in 1 usecs
>
>
> Yours,
> Florian
>

Please attach the full output of:
LIBGL_DEBUG=verbose glxinfo

best,
Jerome Glisse