Can't Get XWindows Up

Jay Cotton Jay.Cotton at Sun.COM
Tue Feb 22 14:00:32 PST 2005


We will also need to know what the monitor is, and the video board.

Ah, I see, KVM  bad juju for EDID code.  KVM's block some of the EDID readback.

Connect the monitor directly to the video board, run Xorg -configure, get the
the xorg.conf file, then connect back to the KVM.  That should get you the
data the server wants, assuming the monitor will provide the EDID data at all. (some don't)

Try this and get back to us.

JC


Van Ingen, Lane wrote:
> I installed XwINDOWS as a part of a Slackware 10.0 distribution. When I try to invoke it
> (startx), I get the erors in the attachment (see log). I think it is because it can't figure out what
> kind of monitor I have or something like that. Tried to use X -configure, but it locked up my
> terminal, which is off a KVM server, with the following message:
>     VIDEO INPUT
>     OUT OF RANGE
>      H: 75.0kHz
>      V: 60.0 kHz
>  
> Don't know where to go from here, what do you suggest?
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> xorg mailing list
> xorg at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/xorg


-- 
	 Jay Cotton 		     Jay.Cotton at sun.com
	 MPK17-2348    x80841
	 Sun Microsystems Inc. - X11 Server Group
	 Operating Platform Group
	
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NOTICE: This email message is for the sole use of the intended
recipient(s) and may contain confidential and privileged information.
Any unauthorized review, use, disclosure or distribution is prohibited.
If you are not the intended recipient, please contact the sender by
reply email and destroy all copies of the original message.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~





More information about the xorg mailing list