[Xorg-driver-geode] FreeBSD 7.0, "X", and ALIX3c3 with Geode Chipset...

[Fred Schnittke]

Hi:

I've setup FreeBSD 7.0 Release on a PC Engines ALIX3c3 board with the
Geode chipset but I can't seem to get "X" to start

This is what I get in xdm.log:

   X.Org X Server 1.4.0
   Release Date: 5 September 2007
   X Protocol Version 11, Revision 0
   Build Operating System: FreeBSD 7.0-RELEASE i386
   Current Operating System: 7.0-RELEASE FreeBSD7.0-RELEASE #0:2008
   root at logan.cse.buffalo.edu:/usr/obj/usr/src/sys/GENERIC i386
   Build Date: 13 February 2008  05:50:12PM

        Before reporting problems, check http://wiki.x.org
        to make sure that you have the latest version.
   Module Loader present
   Markers: (--) probed, (**) from config file, (==) default setting,
           (++) from command line, (!!) notice, (II) informational,
           (WW) warning, (EE) error, (NI) not implemented, (??) unknown.
   (==) Log file: "/var/log/Xorg.0.log", Time: Thu May 15 13:20:59 2008
   (EE) Unable to locate/open config file
   (==) Using default built-in configuration (45 lines)
   (EE) Failed to load module "fbdev" (module does not exist, 0)
   (II) Module "ddc" already built-in
   c000:0282: A2 ILLEGAL EXTENDED X86 OPCODE!

   (EE) VESA(0): Set VBE Mode failed!

   Fatal server error:
   AddScreen/ScreenInit failed for driver 0

   xdm error (pid 24601): xdm error (pid 24593): Server for display :0
   terminated unexpectedly: 1


I’ve tried installing the following two drivers:

   xserver-xorg-video-geode_2.9.0.orig.tar.gz
   xserver-xorg-video-amd_2.7.6.5+git20070208.orig.tar.gz

They will ./configure just fine, but I get all kinds of errors when I run
“make”.

Any help would be appreciated



Regards,


Fred Schnittke
Network Administrator
--------------------------------------------------
There are 10 types of people in the world:
Those who understand binary and those who don't...


----------------------------
Powered by Execulink Webmail
http://www.execulink.com/