RV620 TV-out

[Sergej Pupykin]

  On 09.08.2010 11:10, Alex Deucher wrote:
> Does tv-out work with kms if you force it on with xrandr? load
> detection, which is used for detection on tv-out, is not always
> reliable.
Hello, Alex,

I try

$ xrandr --addmode DIN 640x480
$ xrandr --output DIN --crtc 0 --mode 640x480 --right-of DVI-0
$ xrandr
Screen 0: minimum 320 x 200, current 1920 x 1024, maximum 8192 x 8192
DIN disconnected 640x480+1280+0 (normal left inverted right x axis y 
axis) 0mm x 0mm
    640x480        72.8*
VGA-0 disconnected (normal left inverted right x axis y axis)
DVI-0 connected 1280x1024+0+0 (normal left inverted right x axis y axis) 
340mm x 270mm
    1280x1024      75.0*+   60.0
    1152x864       75.0
    1024x768       75.1     70.1     60.0
    832x624        74.6
    800x600        72.2     75.0     60.3     56.2
    640x480        72.8     75.0     66.7     60.0
    720x400        70.1

But there is no picture on TV.

Also I try
$ xrandr --newmode tv 25.2 640 656 752 800 480 490 492 525 -HSync -VSync
$ xrandr --addmode DIN tv
$ xrandr --output DIN --mode tv
$ xrandr
Screen 0: minimum 320 x 200, current 1280 x 1024, maximum 8192 x 8192
DIN disconnected 640x480+0+0 (normal left inverted right x axis y axis) 
0mm x 0mm
    tv             59.5*
VGA-0 disconnected (normal left inverted right x axis y axis)
DVI-0 connected 1280x1024+0+0 (normal left inverted right x axis y axis) 
340mm x 270mm
    1280x1024      75.0*+   60.0
    1152x864       75.0
    1024x768       75.1     70.1     60.0
    832x624        74.6
    800x600        72.2     75.0     60.3     56.2
    640x480        72.8     75.0     66.7     60.0
    720x400        70.1

with the same result.

$ xrandr --output DIN --set "load detection" 0
has no effect too.