[PATCH 1/2] Mips: ls2k1000: dts: add the display controller device node

[suijingfeng]

On 2023/2/23 16:05, Krzysztof Kozlowski wrote:
> On 23/02/2023 08:58, Krzysztof Kozlowski wrote:
>> On 23/02/2023 04:19, Sui jingfeng wrote:
>>> Hi,
>>>
>>> On 2023/2/23 02:32, Krzysztof Kozlowski wrote:
>>>> On 22/02/2023 17:55, suijingfeng wrote:
>>>>> The display controller is a pci device, it's pci vendor id is
>>>>> 0x0014, it's pci device id is 0x7a06.
>>>>>
>>>>> Signed-off-by: suijingfeng <suijingfeng at loongson.cn>
>>>>> ---
>>>>>    .../boot/dts/loongson/loongson64-2k1000.dtsi  | 21 +++++++++++++++++++
>>>>>    1 file changed, 21 insertions(+)
>>>>>
>>>>> diff --git a/arch/mips/boot/dts/loongson/loongson64-2k1000.dtsi b/arch/mips/boot/dts/loongson/loongson64-2k1000.dtsi
>>>>> index 8143a61111e3..a528af3977d9 100644
>>>>> --- a/arch/mips/boot/dts/loongson/loongson64-2k1000.dtsi
>>>>> +++ b/arch/mips/boot/dts/loongson/loongson64-2k1000.dtsi
>>>>> @@ -31,6 +31,18 @@ memory at 200000 {
>>>>>    			<0x00000001 0x10000000 0x00000001 0xb0000000>; /* 6912 MB at 4352MB */
>>>>>    	};
>>>>>    
>>>>> +	reserved-memory {
>>>>> +		#address-cells = <2>;
>>>>> +		#size-cells = <2>;
>>>>> +		ranges;
>>>>> +
>>>>> +		display_reserved: framebuffer at 30000000 {
>>>>> +			compatible = "shared-dma-pool";
>>>>> +			reg = <0x0 0x30000000 0x0 0x04000000>; /* 64M */
>>>>> +			linux,cma-default;
>>>>> +		};
>>>>> +	};
>>>>> +
>>>>>    	cpu_clk: cpu_clk {
>>>>>    		#clock-cells = <0>;
>>>>>    		compatible = "fixed-clock";
>>>>> @@ -198,6 +210,15 @@ sata at 8,0 {
>>>>>    				interrupt-parent = <&liointc0>;
>>>>>    			};
>>>>>    
>>>>> +			display-controller at 6,0 {
>>>>> +				compatible = "loongson,ls2k1000-dc";
>>>>> +
>>>>> +				reg = <0x3000 0x0 0x0 0x0 0x0>;
>>>>> +				interrupts = <28 IRQ_TYPE_LEVEL_LOW>;
>>>>> +				interrupt-parent = <&liointc0>;
>>>>> +				memory-region = <&display_reserved>;
>>>> NAK.
>>> Err :(,  please give me a chance to explain
>>>> Test your code against the bindings you send.
>>> I can guarantee to you that I test may code more than twice. The code
>>> used to testing is listed at link [1].
>> I wrote - test against the bindings. I don't believe that it was tested.
>> Please paste the output of the testing (dtbs_check).
> OTOH, dtschema has some hickups on loongsoon DTS, so I doubt you could
> even test it. Anyway, where is above property memory-region described in
> the bindings?

Yes, you are right. I forget to write memory-region property.

but the code provided in  loongson64-2k1000.dtsi is correct.

I do run dt_binding_check, the results seems good.

there are some problem when make dtbs_check, but it seems not relevant 
to me.

please give me more time to figure it out, i will reply to you later.

> Best regards,
> Krzysztof