<div dir="ltr"><div><div><div>Hmm, thats weird.  After a little bit from last message I get this in the dmesg<br><br>[ 1656.344768] udl 4-1.3:1.0: swiotlb buffer is full (sz: 2097152 bytes)<br>[ 1656.344772] DMA: Out of SW-IOMMU space for 2097152 bytes at device 4-1.3:1.0<br>[ 1764.517960] [drm] write mode info 153<br><br></div><div>I'm getting lines of these in Xorg.0.log<br>[  1764.008] reporting 3 10 33 266<br>[  1764.008] reporting 3 10 33 266<br>[  1764.008] reporting 3 10 33 266<br>[  1764.009] reporting 3 10 33 266<br>[  1764.009] reporting 3 10 33 266<br>[  1764.009] reporting 3 10 33 266<br>[  1764.010] reporting 3 10 33 266<br>[  1764.010] reporting 3 10 33 266<br>[  1764.010] reporting 3 10 33 266<br></div><div><br></div>Then my xrandr shows up with the stuff it did yesterday.  I switch the mode to one I know the monitor can support and I'm back to the grey screen background.  I can drag windows from one monitor to the next across the screen but my mouse stops at the middle monitor (I'm assuming due to the "Display" in X not allowing the mouse into the other "Display").  <br><br></div>So I'm back to where I was yesterday...  (Almost there, just can't get my mouse onto the third monitor) Anyone have any ideas what was causing all these udl issues above and more importantly, how can I use my mouse on that third monitor?  Finally, assuming I can solve that, what are best practices for saving all this configuration so I don't have to jump through all these hoops to use the udl device?<br><br></div>CAL<br><div><div class="gmail_extra"><br><div class="gmail_quote"><br></div><br></div></div></div>