<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN"> <html> <head> </head> <body bgcolor="#ffffff" text="#000000"> I am encountering unpleasant X behavior after upgrading to an Intel GMA 3100 (G33) graphics device and SuSE 10.3. The driver selected is the "intel" driver. Symptom: <blockquote>Sax presents the XFINE2 test/configuration dialog, the dimensions/orientation buttons can be actuated, but no change to the characteristics of the display occur. The On Screen Display says 91.3kHz/85Hz 1280x1024 no matter what value the test was rated at (in the sax setup dialog, where the test resolution is entered). </blockquote> Symptom: <blockquote>xvidtune starts but when an attempt is made to execute the "test", an error dialog is presented with the message: "Sorry: you have requested a mode-line That is not possible, or not supported by your hardware configuration" - even if when no changes are made to the configuration. </blockquote> Symptom: <blockquote>Although I have at least 4 resolutions defined in the Screens section, the ctl-alt-[+-] chord performs no change. </blockquote> Symptom: <blockquote>Even if I attempt a lower resolution, such as 800x600, sax still reports 1280x1024. </blockquote> Symptom: <blockquote>I have Xorg.0.log and xorg.conf files for this monitor where it runs flawlessly at 1600x1200 - using the SIS Chipset. </blockquote> I have attached two Xorg.0.log files - the first one using the "intel" driver, the second using the "sis" driver - both with the same monitor. I was unsuccessful to force the use of the i810 driver. Any help or suggestions will be greatly appreciated. </body> </html>